Olsberg 14/71-3 Serie Notice D'utilisation page 22

•
Remove the Styrofoam strip between the heating
elements and the top insulation.
fig.18
•
Remove the heating elements with the pre-fitted
cables upwards from the lower insulation and lay
the elements in front of the heater. Use a Styro-
foam strip to lay the elements onto.
Make sure that the element connection tails
and the wire connections are not damaged!
Install the bricks into the heater core, starting with
the lower rear row. For heaters with 3 or 4 bricks
in a row, put the outside bricks in first!
fig.19
22
All manuals and user guides at all-guides.com
•
Build up the complete rear brick columns.
Reinstall the heater elements (fig.20).
Make sure that the element connection tabs are
not damaged and also, that they fit neatly into
the openings in the lower insulation.
Build up the complete front brick columns.(fig.20).
Make certain that the front and back row of
bricks are flush to each other.
fig.20
•
Replace the inner front panel with the insulation
mat facing the bricks.
Make sure that the lower end of the inner front
panel is firmly between the lower insulation
and the lip in the inner housing!
fig.21