Olsberg 14/71-3 Serie Notice D'utilisation page 23

•
Push the inner front panel firmly against the heater
core and fix to the inner housing using the screws
above and on the side.
fig.22
•
Connect the two wires to the direct heating ele-
ment. Ensure that the (6.3mm) push on connectors
are securely fitted, and a good connection is main-
tained with the heating element.
•
Now fix the heater to the wall using the screws
through the heater rear panel left and right.
fig.23
•
Replace the metal-plate with electrical components
for the convector to the heater (fig.10). Make sure
that the screws are the mechanical stop for the
metal-plate. Fasten the two screws.
All manuals and user guides at all-guides.com
•
Remove the tape holding the plastic cover plate of
the adjustment knobs on the upper right side of the
heater rear panel. Lift the cover plate.
•
Check that the air-mixing plate is working correctly.
To do this, turn the output regulator knob from full
left (closed, fig.24) to full right (open, fig.25) and
back. Check that the air-mixing plate is functioning
correctly.
fig.24
fig.25
23