•
Turn the heater upright to stand on its feet.
Make certain that the painted surfaces are not
scratched!
Remember that the heater can easily tilt and fall
forward! If necessary, lean it against the wall!
•
Open the heater:
Take off the plastic covering caps left and right.
Remove the screws.
fig.7
Pull the front panel at the bottom 10cm outwards
from the heater and push upwards to remove.
Take out the Styrofoam strip between the inside
and outside front panels.
fig.8
All manuals and user guides at all-guides.com
Take off the room thermostat knob from the left
side panel.
Remove the fixing screws from the top of the right
and left side panels.
Tilt out the side panels 3cm and push backwards
to remove.
fig.9
•
For wall mounting first the metal-plate which the
electrical components for the convector are con-
nected must be removed. To do this loosen the two
screws of the metal-plate (two turns are enough).
Lift the metal-plate slightly and move it away to the
left side (fig.10).
fig.10
19