Hoshizaki FM-481ALGE Notice D'installation page 3

Machine a glace modulaire
Masquer les pouces Voir aussi pour FM-481ALGE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
ENGLISH
1. UNPACKING
WARNING
Children should not be allowed in reach of
the packaging elements (plastic bags and
expanded polystyrene) as they are potential
sources of danger.
CAUTION
1. Do not lift or manoeuvre the carton by using
the shipping bands.
2. Remove shipping carton, tape(s) and
packing. If packing material is left in the
icemaker, it will not work properly.
Power Supply Cord
Top Panel
Front Panel
Fig. 1
Note: 1. This icemaker needs a Storage Bin.
The recommended Storage Bin is
HOSHIZAKI ICE STORAGE BIN, Model
B-300SD(PD) or B-500SD(PD) with Top
Kit - 8C, B-700SD(PD) with Top Kit - 22C,
or B-900SD(PD) with Top Kit - 22C and Top
Kit - 8C.
2. This icemaker is designed to be connected
to either a multi compressor rack system
or an individual remote compressor using
R404A. To achieve the set evaporating
temperature of -18°C, the running suction
pressure of the compressor should be 2.1
bar or less.
1) After removing the packaging, make sure that
the icemaker and the Storage Bin are in good
condition. If in doubt, please do not use the
equipment but apply to professionally qualified
personnel. See the instruction sheet attached to
the Storage Bin for its unpacking and installation
guidelines.
All manuals and user guides at all-guides.com
2) Remove the shipping tape holding the Front Panel.
3) Remove the Front, Top and Side Panels. See
Fig. 2.
4) Remove the package of accessories, and check
the contents:
Operation Panel
5) Remove the protective plastic film from the panels.
If the icemaker is exposed to the sun or to heat,
remove the film after the icemaker cools.
2. LOCATION
1. This icemaker is not intended for outdoor
2. The installation and operating performance
3. The icemaker should not be located next to
4. The location should provide a firm and level
2
Front Panel
Top Panel:
Remove the screw(s). Lift off.
Front Panel: Remove the screw. Lift up and pull
toward you.
Side Panel:
Remove the screw. Pull slightly
toward you, and lift off.
Fig. 2
a) Installation Kit
Inlet Hose
Outlet Hose
b) Mounting Bracket
IMPORTANT
use. Normal operating ambient temperature
should be within 5°C to 40°C. Water
connection is cold water only. Operation of
the icemaker, for extended periods, outside
of these normal temperature ranges may
affect production capacity.
of the compressor system should be
i n a c c o r d a n c e w i t h t h e r e s p e c t i v e
manufacturer's guidelines and are beyond
the control of Hoshizaki.
ovens, grills or other high heat producing
equipment.
foundation for the equipment.
Top Panel
Side Panel
1
2
2

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fm-481alge-n

Table des Matières