Jet GH-2040ZH Mode D'emploi page 19

Feed Overload Clutch:
To adjust the feed overload clutch, remove the cover (1,
Fig 20) and adjust screw (2).
Be sure not to set it too tight, otherwise no protection
function and the machine may be damaged.
4-Way Toolpost
During tool change, the tool rest is slightly raised.
During tool change, if the tool rest cannot reach the
desired position, loosen the screw (2, Fig 21) for spring
and steel ball.
If it over travels, tighten the screw.
To disassemble the toolpost, remove screw 1 and 2, take
out spring 3 and steel ball 4, then the lever and the tool
rest can be removed.
Fig 20
Cross slide:
The axial play of the cross slide spindle can be
eliminated.
Loosen set screw 1, then tighten screw 2 until the
clearance is eliminated. Finally tighten set screw 1
again. When the adjustment is finished, put on the
dust cover 3 (See Fig 22).
The dovetail guide ways on cross and top slide are
adjustable by tapered gibs.
18
Fig 21
Fig 22