Alarm Configuration Page - Bodet Time Profil 960 Manuel D'installation Et De Mise En Service

6.4 Alarm configuration page

This page is used to configure the IP addresses of servers which receive the error messages sent
by the monitored clocks. You can choose which parameter or parameters to define as alarms, and
configure them.
The information displayed is described below:
- Enable SNMP Trap checkbox: enables or disables automatic sending of error messages to the
SNMP Manager(s).
- SNMP Manager 1/2/3: IP addresses of servers to receive clock alarms. Using redundant SNMP
Managers allows a network to be filtered/structured at different levels (e.g. local, regional, national).
- Community: user-defined clock pool or domain.
- Synchronisation failure: this parameter enables detection of synchronisation faults with the
"source" (Sigma Master clock).
29