Overview Of The Components; Start-Up Of The Device/Introduction - AEG MC 4465 BT Mode D'emploi

All manuals and user guides at all-guides.com
CAUTION:
• Do not use the device at maximum volume. That could
cause damage.
• Make sure the bare wires of the speaker do not touch
each other/intersect. Risk of short circuit!
• Do not touch the speaker membranes with hands or
objects. That could damage the membranes.

Overview of the Components

1 Display
2 VOLUME –/+ rotary control
3 IR receiver for the remote control
4 FUNCTION button
5 EQ button (equalizer)
6 button
7 DISPLAY/ID3 button
8 FOLDER/PRE button
9 /TUNE+ button
10 button (open CD tray)
11 Headphone connection
12 AUX-IN input
13 USB port
14 Memory card slot
15 CD compartment
16 LIGHT/TIMER button
17 /TUNE– button
18 /FOLDER/PRE button
19 PLAY MODE button
20 ST/MO/ button
21 MEM/CLK-ADJ button
22 I/ button
23 control lamp (operating status)
Reverse (not shown)
SPEAKER R/L loudspeaker connections
SPEAKER LIGHT connections
Mains cable
FM wire antenn
Remote control
1 MEM/CLK-ADJ button
2 FUNCTION button
3 button
4 /TUNE+ button
5 /ST/MO button
6 -10 / +10 buttons
7 VOL–/VOL+ buttons
8 PRESET EQ button
9 DISPLAY/ID3 button
10 MUTE button
11 SLEEP button
12 TIMER/LIGHT button
13 PLAY MODE button
14 button
15 FOLDER/PRE / FOLDER/PRE buttons
16 /TUNE– button
17 I/ button

Start-up of the device/introduction

• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
• Sensitive surfaces, such as the display, might be protect-
ed with foils. Remove such foils.
Connecting the speakers
1. Clamp the speaker cables of the respective box to the
corresponding terminal on the rear of the device. While
doing so, observe correct polarity ("red to red" and "black
to black").
2. Also connect the 3.5 mm jack plugs of the speakers to
the connections SPEAKER LIGHT "R" and "L".
Power Supply
• Ensure that the voltage is the same as that indicated on
the model identification plate.
• Connect the mains plug to a properly installed wall
socket.
NOTE:
If the unit is not used for a long period of time, unplug the
mains plug from the socket.
Inserting the batteries into the remote control (not sup-
plied)
1. Open the lid of the battery compartment on the bottom.
2. Insert 2 batteries of type AAA/R03 1.5 V. Please ensure
that the polarity is correct (see the floor of the battery
compartment)!
3. Then close the battery lid.
CAUTION:
• Batteries can leak and lose battery acid. If the remote
control is not used for a long period of time, remove
the batteries.
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
English
49