Using The Stopwatch - Carrera RC Race Copter Instructions De Montage Et D'utilisation

Masquer les pouces Voir aussi pour Race Copter:
Table des Matières

Publicité

• The Quadrocopter is now ready to be flown.
• If the Quadrocopter displays no functions,
retry the above binding procedure.
• Fly the model.
• Land the model.
• Disconnect the battery plug connection.
• Always switch off the remote control last.
Flying the 4-channel Quadrocopter
NOTE!
Take care particularly in the first few
flights to move the lever on the controller
very gently and not over-hurriedly. As a
rule, only very small movements of the re-
spective levers are necessary to carry out
the desired control commands!
If you notice that the Quadrocopter moves
forwards or to the side without your touching
the respective lever, please adjust the trim of
the Quadrocopter as described in
9
+/- Gas (up / down)
To start or to fly higher, push the gas le-
ver on the left cautiously forwards. To land
or fly lower, push the gas lever on the left
cautiously backwards.
10
To make the Quadrocopter circle to the left
or the right on the spot, move the lever on
the left cautiously to the left or the right.
11
To fly the Quadrocopter to the left or the
right, push the lever on the right cautiously
to the left or the right.
12
To fly the Quadrocopter forwards or back-
wards, push the lever on the right cautious-
ly forwards or backwards.
Start the rotors and motors
13 a
Press the 'Start/Stop rotors' button on
the controller, in order to start the motors.
You can lift the throttle control upwards as
soon as the rotors are running.
All manuals and user guides at all-guides.com

Using the stopwatch

13 b
auto-start by pressing the "MIN" or "SEC" button.
Press on the "ST" button to start the countdown.
Press briefly on "ST" to pause. Keep pressed
for longer (5 seconds) to reset the time."
As soon as the countdown reaches 0:00, the
Quadrocopter starts its rotors and flies to 1 m
height. The time now runs automatically.
Stop the stopwatch by pressing the "ST" but-
ton. Keep pressed for longer (5 seconds) to
reset the time.
Beginner/Advanced switch
13 c
.
17
18 19 20
WARNING!
100 % IS ONLY FOR EXPERIENCED PILOTS!
Automatic control of altitude
14
Auto Landing
15
21
ENGLISH
Select the time for the countdown to the
30% = beginner mode
Signal sounds once on switching over.
60% = medium mode
The quadrocopter reacts more sensitively
than in 30 % mode. Signal sounds twice
on switching over.
100% = Advanced Modus -> 3D Modus
The Quadrocopter reacts very sensitive-
ly to joystick movements. Signal sounds
three times on switching over.
The Quadrocopter will maintain the cur-
rent flying altitude automatically as soon
as you release the left-hand joystick dur-
ing the flight.
You can trigger the automatic landing func-
tion at any time by means of pressing the
'Auto landing' button. The speed of the ro-
tors will reduce gradually as a result. You
are able to influence the landing position at
any time during the landing procedure by
means of moving the right-hand joystick.
The motor will switch itself off as soon as
the Quadrocopter is on the ground.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

370503022

Table des Matières