Using The Breast Pump - Philips AVENT SCF394 Mode D'emploi

English
12
Step 3: Disinfecting
Supplies needed:
A household pot
-
Drinking-quality water
-
Caution: During disinfection with boiling water, prevent the bottle or other parts from
touching the side of the pot. This can cause irreversible product deformation or damage
that Philips cannot be held liable for.
5 min.
1. Fill a household pot
with enough water
to cover all parts and
place all parts in the pot.
Let the water boil for
5 minutes. Make sure the
parts do not touch the
side of the pot.

Using the breast pump

Cushion size
The Philips Avent single/double electric breast pump Premium Plus has a soft, active cushion. There is
only one cushion size. It gently stimulates your nipple to trigger milk flow. The cushion is made of flexible
silicone, fitting nipple sizes up to 30 mm/1.18 in.
Charging the breast pump
Fully charge the battery before you use the breast pump for the first time and when the battery is low.
Fully charging the battery takes up to 4 hours.
3 sec.
1. Switch off the device.
2. Allow the water to
cool down.
2. Insert the adapter
into the wall socket and
insert the small plug at
the other end into the
motor unit.
3. Gently remove the
parts from the water.
Place the parts on a clean
surface/tea towel or
drying rack to air-dry.
3. The battery is
charging.
4. Store the dry items
safely in a clean, protected
area until needed. Ensure
that the clean parts have
air-dried completely
before storing them to
help prevent germs and
mold from growing.
4. When the battery is
fully charged, remove the
adapter from the wall
socket and pull the small
plug out of the motor unit.