Using The Breast Pump; Assembling The Breast Pump - Philips AVENT SCF397 Mode D'emploi

English
12
Caution: During disinfection with boiling water, prevent the bottle or other parts from
touching the side of the pan. This can cause irreversible product deformation or damage
that Philips cannot be held liable for.
5 min.
1. Fill a household pot
with enough water to
cover all parts and place
all parts in the pot. Let
the water boil for
5 minutes. Make sure
the parts do not touch
the side of the pot.

Using the breast pump

Cushion size
The Philips Avent single/double electric breast pump has a soft, active cushion. It gently stimulates
your nipple to trigger milk flow. The cushion is made of flexible silicone, that adapts to up to 99.98 %
of women, fitting nipple sizes up to 30 mm.

Assembling the breast pump

Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with
milk.
Warning: Be careful, when you have disinfected the breast pump parts by boiling
them, they can be very hot. To prevent burns, only start assembling the breast pump
when disinfected parts have cooled down.
Warning: Wash your hands thoroughly with soap and water before you touch breast
pump parts and breasts to prevent contamination. Avoid touching the inside of
containers or lids.
Check the breast pump kit parts for wear or damage before use and replace them if necessary.
Note: Correct placement of the cushion, silicone diaphragm and silicone tube is essential for the
breast pump to form a proper vacuum.
2. Allow the water to
cool down.
3. Gently remove the
parts from the water.
Place the parts on a
clean surface/tea towel
or drying rack to air-dry.
4. Store the dry items in
a clean, dry and covered
container.