Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
RP114279 Küchenmaschine mit Heizung LB2 Seite 94 Montag, 12. Januar 2015 9:50 09
10. Cleaning and maintaining the appliance
Warning! To prevent the risk of
electric shock, injury or damage:
• Always take the mains plug out of its
socket before cleaning.
• Never immerse the base unit 17 in water.
• Remember that the blades in the blender
jug 20 are extremely sharp. Never
touch them with your bare hands to
avoid cutting yourself.
Caution! Never use scouring, corrosive or
abrasive cleaning materials as these might
damage the appliance.
10.1 Cleaning the base unit
1. Clean the base unit 17 with a damp
cloth. A little detergent may also be
used.
2. Wipe over with clean water.
3. Do not use the base unit 17 again until it
is completely dry.
10.2 Cleaning the blender jug
1. Place the blender jug 6 containing the
blade assembly on the appliance 20.
2. Half fill it with hot water.
3. Put the lids for the blender jug 25 and its
fill opening with measuring scale 26 in
place.
4. Insert the power supply plug into a
suitable mains socket (see "3. Technical
data" on page 78).
5. Press the pulse button briefly several
times 9.
6. Take the jug 6 off the appliance.
7. Pour away the water.
The blender jug 6 is now pre-cleaned.
94
8. Remove the blade assembly 20 (see
"7.2 Inserting and removing the blade
assembly" on page 85)..
9. Clean the blender jug 6 by hand in the
sink with soapy water.
10.Then rinse it 6 thoroughly under clear
water.
11. Allow the jug 6 to dry completely before
using it again.
10.3 Cleaning the accessories
Warning!
assembly 20
has
blades. To avoid injury, please
observe the following information:
• Remember that the blades of the
assembly 20 are extremely sharp.
Never touch them with your bare hands
to avoid cutting yourself.
• When washing up by hand, the water
should be clear enough that you can
easily see the blade assembly 20 and
do not risk cutting yourself on its
extremely sharp blades.
1. Remove the blade assembly 20 from the
blender jug 6 (see "7.2 Inserting and
removing the blade assembly" on
page 85).
2. Remove the seal 19 from the blade
assembly 20.
3. Remove the seal 24 from the lid of the
blender jug 25.
4. Remove the seal 5 from the drip tray 4.
5. Clean all the accessories by hand in the
sink.
6. Allow all parts to become completely
dry.
7. Replace the seal 5 in the drip tray 4.
The
blade
very
sharp
Publicité
Table des Matières
