Malfunctions, Causes And Solutions; Malfunctions During Operation - SilverCrest SKMH 1100 A1 Mode D'emploi

All manuals and user guides at all-guides.com
RP114279 Küchenmaschine mit Heizung LB2 Seite 96 Montag, 12. Januar 2015 9:50 09

11. Malfunctions, causes and solutions

11.1 Malfunctions during operation

Malfunction
Appliance fails to start
There is liquid
underneath the
appliance
Liquid is leaking from the
lid 25 of the blender
jug 6
Unable to select a
temperature
96
Cause
Blender jug 6 is not correctly
positioned
Lid 25 of the blender jug 6
is not correctly positioned
No power supply
Incorrect power supply
Blade assembly 20 is not
correctly seated and is
leaking
The seal of the blade
assembly 19 is defective
Liquid has escaped from the
blender jug 6 and has
drained through the base
unit's overflow hole 17 onto
the underlay (see
"6.9 Overflow" on
page 85)
Seal 24 is not correctly
positioned
Seal 24 is defective
You have selected a speed
in the range 4 – 10
Solution
Position the blender jug 6 correctly
(see "7.3 Positioning the blender
jug" on page 86)
Position the lid 25 correctly (see
"7.5 Positioning the lid of the
blender jug" on page 87)
Check the plug and if necessary
also the fuse
Make sure to use the correct power
supply (see "6.1 Connecting the
power supply" on page 82)
Position the blade assembly 20
correctly (see "7.2 Inserting and
removing the blade assembly" on
page 85)
Install a new seal 19 (see
"10.6 Ordering seals" on page 95)
When blending liquids on level 10 or
using the pulse button 9, do not
exceed a quantity of 1 litre in the
blender jug 6, otherwise liquid may
spray out. At speeds lower than 10,
the blender jug may contain up to 2 l.
Position the seal 24 correctly (see
"10.3 Cleaning the accessories" on
page 94)
Install a new seal 24 (see
"10.6 Ordering seals" on page 95)
Select a speed in the range 0 – 3
(see "6.6 Setting the speed" on
page 84)