Topcom Butler 2450 Mode D'emploi page 20

All manuals and user guides at all-guides.com
HANDL. B2450_euro.qxd 19/7/02
Butler 2450
4.25 Subscribing Butler 2450 handset on another base (other brand/model)
Put the base in subscription mode (see manual of the base). If the base is in subscribing mode,
you have to do the following to subscribe the handset:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'BASE _' appears on the display.
• Enter a number for the base unit to which you would like to subscribe the handset (1-4).
Use the number keypad.
• 'SEARCHING' and the symbol
• The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal
sounds once the base unit is found by the handset.
• Press the Programming key
• 'PIN' appears on the display.
• Enter the 4-digit PIN code of the base unit (default PIN code is '1590'). Use the number keypad.
• Press the Programming key
• The handset is subscribed to the base unit.
4.26 Subscribing a Butler 1800T handset to a Butler 24xx base unit
The below procedure only applies to a Butler 1800T handset and Butler 24xx base unit!!
Press the Paging key
op the base unit starts to blink quickly. The Line/Charge indicator
minute. During this minute, the base unit is in subscribing mode and you must do the
following to subscribe the handset:
• Press the key once.
• Press the OK key and select a base unit (1-4) with the
• Press the OK key.
• Enter the PIN code of your base unit. Usually: 0000.
• Press OK. The Butler 1800T now searches for your DECT base unit. As soon as it finds it, you
will see the identification code of this base unit on the display.
• Press OK to confirm your selection or press ESC to cancel the subscription.
4.27 Removing subscription of a handset to a base unit
It is possible to cancel subscription of a handset to a base unit. You would do this if a
handset is damaged and has to be replaced by a new one.
Caution: You can only cancel subscription of another handset, not the handset you are using to do the
cancellation procedure.
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'PIN' appears on the display.
• Enter your 4-digit PIN code in (default PIN code is '0000'). Use the number keypad.
2:56 pm Page 20
.
repeatedly until 'BASE SUB' appears on the display.
.
appear on the display.
.
.
on the base unit for 10 seconds until the Line/Charge indicator
.
repeatedly until 'SETTING' appears on the display.
.
repeatedly until 'REMOVE HS' appears on the display.
.
20 20 20 20 20 20 20 20 20 20 20 20
will blink quickly for one
keys.