Electrical Connection - Hotpoint Ariston HHBS 9.8C LTD K Mode D'emploi

ELECTRICAL CONNECTION

The mains power supply must correspond to the rating indicated on the plate situated
inside the hood. If provided with a plug connect the hood to a socket in compliance with
current regulations and positioned in an accessible area, after installation. If it not fitted
with a plug (direct mains connection) or if the plug is not located in an accessible area,
after installation, apply a double pole switch in accordance with standards which
assures the complete disconnection of the mains under conditions relating to over-
current category III, in accordance with installation instructions.
WARNING! Before re-connecting the hood circuit to the mains supply and checking
the efficient function, always check that the mains cable is correctly assembled.
If the cable is not fitted with a plug, connect the wires according to the following table:
Mains voltage and frequency
Refer to the rating indicated on the plate inside of the hood
Replacing the power cable
The hood is provided with a special power cable ; if the cable is damaged, request a
new one from Technical Service.
AIR VENT
FILTERING OR DUCTING ?
Your cooker hood is designed to be used only in filtering version.
The aspirated air will be degreased and deodorised before being fed back into the room.
The filtering system
Note: due to its technical characteristics, it is not possible to use the hood in the extraction mode
Important! To proceed with the installation it is necessary to use a tube of flexible type
provides a High
23
Wire connection
: yellow/green
N : blue
L : brown
Performance activated charcoal filter