Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
E-MAXX QUICK START GUIDE
The following guide is an overview of the procedures for getting your
model running. The complete manual for your model can be viewed
and downloaded by following the link on the cover of this manual, or
by scanning the QR code. Please read this entire manual for complete
instructions on the proper use and maintenance of your model.
Read the Safety Precautions
For your own safety, understand where carelessness and misuse could
lead to personal injury and product damage.
Prepare Your Model
Charge the battery packs
Your model requires a battery charger designed for NiMH batteries.
The #2930 Traxxas EZ-Peak charger is recommended for your model.
Install batteries in the transmitter
The transmitter requires 4 AA alkaline or rechargeable batteries.
Install the battery packs in the model
The included batteries must be fully charged
before installation in the model. Install the battery
pack with the battery wires facing the rear of the
model. Insert the tabs of the battery hold-down
into the slots in the rear hold-down retainer (A).
Swing the battery hold down towards the chassis
and snap (lock) the end into the front hold-down
retainer (B).
Compatible batteries:
• 12-14 cell NiMH
• 2-cell and 4-cell LiPo
Activate Low-Voltage Detection when using
Release Tab
LiPo batteries
All manuals and user guides at all-guides.com
Turning on Your Model
Turn on the transmitter
Always turn the transmitter on first, before turning on the model.
The transmitter's LED will glow.
Plug the batteries into the speed control
Align the + and – markings. Make certain the plugs are fully engaged.
Turn on the model
Press and release the EZ-Set button on the speed control. The speed
control's LED will glow.
Before Operating Your Model
Check servo operation
Confirm the model's wheels turn right
and left when the transmitter steering
wheel is turned right and left.
The front wheels should be pointing
straight ahead. If they are turned slightly,
slowly adjust the steering trim control on
the transmitter until they are pointing straight ahead.
Range test the radio system
With a friend's help, check servo operation at a distance and that
there is no interference before running your model.
Operating Your Model
Note: Return the transmitter's trigger neutral and push up again to
activate reverse throttle
1
2
Always turn your
Plug in the battery.
transmitter on first.
Neutral
If the model becomes stuck against an object, do not continue
to run the motor. Remove the obstruction before continuing. Do
not push or pull objects with the model.
3
Turn on the model.
Brake/Reverse
Forward
TRAXXAS • 5
Publicité
Table des Matières
