Cleaning And Maintenance - HSM Primo 1200 Notice D'utilisation

5 Troubleshooting
Paper jam
You have fed in too much paper.
NOTICE! Do not press rocker switch alter-
nately forwards/backwards (
Cutting unit could be damaged.
• Press rocker switch
Pa per is pus hed out.
• Se pa ra te pa per stack.
• Press rocker switch
• Feed in pa per sheets successively.
Shredded material container full
NOTICE! Empty the cut material container,
immediately because if it is too full,
malfunctions can occur in the cutting
system.
• Press automatic start stop control
for 2 sec.
• Switch equipment off. To do this tap
rocker switch
• Empty cut material container.
Shredded material container contact
interrupted (Cross cut only)
Document shredder switches off.
• Check whether shredded material
container is correctly inserted in bot-
tom frame.
For all other malfunctions, check whether the
motor was overloaded before contacting our
customer service. Let the shredder cool down
for approx. 15 – 20 mins. before using it again.
0802
All manuals and user guides at all-guides.com
Switch off the shredder and pull out the mains
plug.
When cleaning only use a soft cloth and a mild
soap-water solution. However, no water must
- ).
enter the equipment.
.
.
• Spray special cutting block oil through paper
• Press automatic start stop control and run
.
HSM 102.2
Primo 1200

6 Cleaning and maintenance

Oil the cutting unit when
cutting performance
decreases or the device
becomes noisy, or every
time you empty the waste
container (Cross cut only):
feed opening across the whole width of the
cutting system blades.
cutting system forwards and backwards
( ) several times without feeding paper.
-
Paper dust and particles are shaken off.
9