Cleaning And Maintenance - HSM SECURIO B 22 Notice D'utilisation

6 Troubleshooting
Paper jam
You have fed in too much paper.
Notice Do not press rocker switch
alternately forwards/backwards („I" - „R").
Cutting unit could be damaged.
• Press rocker switch „R".
Pa per is pus hed out.
• Se pa ra te pa per stack.
• Press rocker switch „I".
• Feed in pa per successively.
Shredded material container full
Paper shredder switches off.
Notice Empty the cut material contain-
er, immediately because if it is too full, mal-
functions can occur in the cutting system.
• Switch equipment off. To do this
tap rocker switch „R".
• Empty cut material container.
Shredded material container contact
interrupted
Paper shredder switches off.
• Check whether shredded mate-
rial container is correctly inserted
in bottom frame.
For all other malfunctions, check whether
the motor was overloaded before contacting
our customer service. Let the shredder cool
down for approx. 15 – 20 mins. before using
it again.
12

7 Cleaning and maintenance

WARNING
Dangerous mains voltage!
Switch off the shredder and pull
out the mains plug.
When cleaning only use a soft cloth and a
mild soap-water solution. However, no water
must enter the equipment.
container (Cross cut only).
unit oil through the paper feed along the
entire width of the cutting shafts.
• Run cutting system backwards (pos. "R")
without feeding paper.
Paper dust and particles are shaken off.
Note
Oiling the cutting unit also improves the cut-
ting performance of devices with strip cut.
SECURIO B 22
english
Oil the cutting unit when
cutting performance de-
creases or the device
becomes noisy, or every
time you empty the waste
Only use HSM special
lubricating oil for the
cutting unit to do this:
• Spray the special cutting
09/2011