Siemens PolyCool CPS 40 Manuel D'installation Et D'utilisation page 37

Picture Function Parameter
Valve startup
opening limit
Pressure sensor
alarm delay when
compressor ON
Low limit for
temperature
measurement
Minimum
superheat ∆T
Remark
Building Technologies
HVAC Products
Code Adjustable
VO
PA
4)
TL
MI
1)
Can be parameterized only if external or internal capacity control
has been selected in the configuration mode.
2)
SD can be parameterized only if external capacity control has
been selected in the configuration mode.
SD = -1
means that 0 V / 4 mA corresponds to max. cooling capacity
SD = 1
means that 0 V / 4 mA corresponds to min. cooling capacity
3)
Operation safety control
4)
Once the actual temperature value is over this limit of TL, an
alarm will appear.
The MOP function can be set up using the parameters.
Normaly, the factory settings should not be changed.
CPS40
Range/increment
0...50 % / 1 %
0...30 s / 1 s
-50...-40 °C / 1 °C
-58...-40°F / 1 °F
0...4 K / 0...7.2 °F
CE1U3372XX / H 74 319 0555 0 a
Settings Procedure
Default
0 %
5 s
-40 °C /
1 °C
-40 °F /
1 °F
2 K /
3.6 °F
37/124
22.09.2006