Replacing The Lamp; Closing The Door; Installation; Rear Spacers - Fust NOVAMATIC KS 196.2-IB Notice D'utilisation

All manuals and user guides at all-guides.com
46

Replacing the lamp

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

INSTALLATION
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
This appliance can be installed in a dry, well
ventilated indoor, also in a garage or cellar,
but for optimum performance install this ap-
pliance at a location where the ambient
temperature corresponds to the climate

Rear spacers

4
2
1
3
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp cov-
er.
3. Remove the lamp cover (refer to the il-
lustration).
4. Replace the used lamp with a new
lamp of the same power and specifical-
ly designed for household appliances.
(the maximum power is shown on the
lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
socket.
8. Open the door. Make sure that the
lamp comes on.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
class indicated on the rating plate of the ap-
pliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.