Installation And Connection; Operating - Bartscher 135.102 Mode D'emploi

•
Do not leave the device unsupervised when in use, especially if there are children
nearby.
•
Never touch moving elements when the device is in use.
•
Ensure there are no objects (spoon, knife, etc.) in the device before it is turned
on. Risk of injury!
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

•
Unpack the device and remove all packing material.
•
Place the device on a flat, secure surface that can support the device's weight and is
dry.
•
Never place the device on a flammable surface.
•
Do not place the device near an open flame, electric or other heater, nor any other
source of high temperatures.
•
Check that the suction cups are securely attached to the surface underneath.
•
The electrical circuit must be secured to a minimum of 16A. Connect the device
directly to a grounded wall socket; do not use extension cords or power strips.
•
Place the device so that the socket is easily accessible and if needed the device can
be quickly disconnected from its power source.

5.3 Operating

•
Before use, carefully clean the mixing rod with disks and shakers
(see 6.2 "Cleaning").
•
Wipe the device's exterior with a moist, soft cloth.
•
Insert the device's plug into a grounded single socket.
•
Check that the switch is in the position marked "O".
•
Fill the shakers with the desired ingredients.
- 21 -