Télécharger Imprimer la page

Hella 2NE 959 011-5 Serie Instructions

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

INSTRUCTION SHEET
2NE 959 011-5xx
for:
APPLICATION AND
MOUNTING INSTRUCTIONS
83mm ROUND REAR FOG LAMP
Multivolt 9-33 Volts
Features
24 LED design
Low power consumption
Ultra fast response time
Reverse polarity protected
Built-in transient spike protection
Ultra long service life
Lens Marking and Installation Requirements
This Rear Fog Lamp Lamp, identified by lens marking E4 11391 and the
comply with ECE Regulation 38 Category F1 for Rear Fog Lamps
A tolerance of +/-3 degrees applies on all mounting details.
Lamp mounting surface must be vertical to the ground, and at right angles to the longitudinal axis of the
vehicle.
One or two lamps are required.
If one lamp is mounted it must be left of centre for right-hand trafffic and right of centre for left-hand
traffic.
Lamps must not be mounted less than 250 mm and more than 1000 mm above the ground.
Lamp must be visible from 25° inboard and 25° outboard, as well as from 5° above and 5° below the
horizontal axis.
Lamp is approved to be mounted only with lens engraving "TOP" located correctly.
Rear View
TOP
9010
HELLA-New Zealand Limited, Auckland, New Zealand
Fully sealed against dust and water
Withstands most vibration and mechanical shock
applications
Manufactured from the latest "high tech" acrylic
with enhanced impact and chemical tolerance
Flush mount for low profile appearance
logo was manufactured to
Side View
Top View
959 150-60 / 12.20

Publicité

loading

Sommaire des Matières pour Hella 2NE 959 011-5 Serie

  • Page 1 Lamp must be visible from 25° inboard and 25° outboard, as well as from 5° above and 5° below the horizontal axis. • Lamp is approved to be mounted only with lens engraving "TOP" located correctly. Side View Rear View Top View 9010 HELLA-New Zealand Limited, Auckland, New Zealand 959 150-60 / 12.20...
  • Page 2 Ensure the lens engraving "TOP" is located correctly. Operation of this lamp using alternating current or modulated direct voltage will cause premature light failure. HELLA recommends connecting ADR or ECE certified Multivolt LED signal and marker lamps to a continuous Connect lamp wiring as per chart below.
  • Page 3 5º de part et d'autre de l'axe horizontal. • La lampe a été conçue et certifiée pour un montage avec l'inscription "TOP" située au sommet de l'unité. Vue arrière Vue du dessus Vue latérale 9010 Hella-New Zealand Limited, Auckland...
  • Page 4 à LED. Codage couleur du câblage Depuis la mise sur le marché du premier feu de signalisation à LED en 1990, les produits HELLA se sont établis comme des références en termes de conception et d’innovation. Afin de résister aux Ce feu est "Multivolt"...