Timer; Oscillation; Special Mode; Operating Mode "Nature Mode - Rotel U7711CH Mode D'emploi

• TIMER

o
Using the timer you can programme the fan so that it turns off automatically after a
set period of time.
▪
First turn the fan on by pressing the "ON/SPEED" (B) button. You can set the
number of fans and speed you want before or after programming the Timer.
▪
Now press the "TIMER" (E) button until you reach the running time you want.
You can set this at half an hour intervals from 0.5 hours to 7.5 hours.
▪
When the Timer turns on, the symbol "0.5" under the Timer button lights up.
This means that the device will turn off after half an hour.
▪
Each time you press the Timer button you extend this time by half an hour.
▪
You can check how long you have set it for by adding up the hours indicated on
the illuminated symbols. For example, the symbols "2" and "1" light up = The
appliance is programmed to run for 3 hours.
▪
You can delete the programming by switching the appliance off with the "OFF"
(A) button and then switching it back on again.

• OSCILLATION

o
You can switch the oscillating movement of the fan on and off with the "SWING" (D)
button.
o
The symbol under the "SWING" button lights up when the oscillating feature is
switched on.

• SPECIAL MODE

Operating mode "Nature Mode"

o
Depending on the setting of the fan at level 1, 2 or 3, the appliance alternates
between the different levels at varying intervals. For example, when the fan is set at
level 1, the "Nature" mode alternates from 5 seconds of low fanning to 5 seconds
without fanning.
o
Using the "ON/SPEED" button (B) select the fanning level you want and use the
"SHIFT" button (F) to select the number of fans.
o
Press the "MODE" button (C) until the symbol with the palm tree lights up.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
32