Assembly; Control Panel; Fan; Speed - Rotel U7711CH Mode D'emploi

• ASSEMBLY

o
Place the lower part of the column (3) in the separately delivered base (4) and tighten
the nut as shown in the diagram. Make sure that the nut is tightened properly so that
the fan is stable.

• CONTROL PANEL

o
The panel is fitted with a "Touch screen" which makes it really easy to operate the
appliance by simply tapping on the symbols.

• FAN

o
The appliance has three fans which can be turned on and off individually.
o
Turn the fan on by pressing the "ON/SPEED" (B) button on the panel.
o
All three fans are switched on at the lowest level 1 and the symbols for the individual
fans as well as the symbol for level 1 light up.
o
By pressing the "SHIFT" (F) button, the symbols for the fans start to flash.
o
Whilst the symbols are flashing, you can turn the individual fans on and off by
pressing the corresponding buttons:
▪
Fan 1 (top)
▪
Fan 2 (middle) = button D
▪
Fan 3 (bottom) = button E

• SPEED

o
By pressing the "ON/SPEED" (B) button again you can select one of the three settings:
o
Level 1 = Low / Level 2 = Medium / Level 3 = High
o
The level that has been selected is displayed with a special symbol under the
"ON/SPEED" button in the lower part of the panel.
o
The fan can be turned off at any time by pressing the "OFF" (A) button.
o
The last selected setting for the number of fans and the speed is stored and comes
on automatically when the appliance is turned back on again with the "ON/SPEED"
button.
o
As soon as the plug is pulled out, this programming is deleted.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
= button C
31