Breville the Duo-Temp Pro BES810 Manuel D'instructions page 8

Masquer les pouces Voir aussi pour the Duo-Temp Pro BES810:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING YOUR BREVILLE PRODUCT
FILLING THE WATER TANK
Ensure the water filter is securely fitted
inside the tank.
Fill the water tank with cold tap water
to the maximum mark on the side of the
tank and slide the water tank back into
position at the back of the machine.
Plug the power cord into power outlet.
Press the POWER button. The POWER
button surround will flash while the
machine is heating. When the correct
temperature has been reached, all the
button surrounds on the control panel
will illuminate.
NOTE
Check the water level before use and
replace the water daily. The water
tank should be filled with fresh, cold
tap water before each use. Do not use
de-mineralized or distilled water or
any other liquid.
COFFEE PREPARATION
Dose & Tamping the Ground Coffee
If using whole bean coffee ground directly
before extracting, use the Single Wall Filter
Baskets. If using Pre-ground coffee, use
the Dual Wall Filter Baskets. Insert the
correct Filter Basket into the portafilter.
Fill the Filter Basket with ground coffee,
tap down to collapse the coffee, then using
the integrated tamper, tamp down firmly
(approx. 15-20kg of pressure).
14
It's important to apply consistent pressure
every time.
As a guide to dose, the top edge of the
metal cap on the tamper should be level
with the top of the filter basket AFTER
the coffee has been tamped. This will
minimize under or over dosing the
coffee.
Wipe excess coffee from the rim of the
filter basket to ensure a proper seal in
the group head is achieved.
TRIMMING THE DOSE
The Razor™ precision dose trimming tool
allows you to trim the puck to the right
level for a consistent extraction.
Razor
the
Precision dose trimming tool
Refer to Coffee Making Tips & Preparation,
page 17 for more details.
OPERATING YOUR BREVILLE PRODUCT
EXTRACTING ESPRESSO
Insert the Portafilter into the Group Head
& lock into position. Turn the Control Dial
to the 'Espresso' position. A pumping noise
will be heard. After a few seconds, coffee will
begin to brew into the cup.
When sufficient coffee has been extracted,
turn the Control Dial to 'Standby'. This will
stop the flow of coffee. Breville recommends
approx. 30 sec of extraction.
NOTE
For optimal flavor when using a
1 CUP filter, you should extract approx.
1oz. When using a 2 CUP filter, you
should extract approx. 2oz.
LOW PRESSURE PRE-INFUSION
The low pressure pre-infusion gradually
increases water pressure to gently expand
grinds for an even extraction before
increasing to full pressure.
WARNING
The metal parts of the portafilter
will be very hot.
NOTE
If machine is run continuously for
30 minutes, allow machine to cool for
5 minutes before the next use.
15

Publicité

Chapitres

Table des Matières
loading

Table des Matières