Manufacturer's Warranty - Tools - Hilti GX90-WF Mode D'emploi

Fault
The fan does not start, no LED
lights up
The fan does not start, the LED
lights up in red
The fan is running, the tool does
not fire
en
The tool can not be pressed
against the work surface
12 Disposal
Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must
be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back old tools and appliances for recycling. Ask Hilti customer service or your Hilti representative for further
information. If you wish to bring the tool to a materials separation facility yourself: Regional and international directives
and regulations must be observed.

13 Manufacturer's warranty - tools

Hilti warrants that the tool supplied is free of defects in
material and workmanship. This warranty is valid so long
as the tool is operated and handled correctly, cleaned
and serviced properly and in accordance with the Hilti
Operating Instructions, and the technical system is main-
tained. This means that only original Hilti consumables,
components and spare parts may be used in the tool.
This warranty provides the free-of-charge repair or re-
placement of defective parts only over the entire lifespan
of the tool. Parts requiring repair or replacement as a
result of normal wear and tear are not covered by this
warranty.
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular, Hilti
is not obligated for direct, indirect, incidental or con-
22
All manuals and user guides at all-guides.com
Possible cause
If the problem remains: No battery
voltage
The battery voltage is not sufficient to
operate the tool
Empty gas can
Tool requires cleaning service
Less than 5 nails in the magazine
Nails jammed
Remedy
Insert another battery.
Charge the battery.
Insert another battery.
Charge the battery.
Insert a new gas can.
See section: 6.2 Preparing the gas
can
See section: 6.2.2 Inserting the gas
can 5
Clean the tool/arrange to have it
cleaned.
See section: 10.3 Cleaning the tool 11
Add more nail strips.
See section: 6.1 Inserting nails 2 3
Remove the battery and gas can.
WARNING
N.B.: Do not carry out any mainten-
ance work without fully unloading the
tool.
Remove the jammed nails.
sequential damages, losses or expenses in connec-
tion with, or by reason of, the use of, or inability to
use the tool for any purpose. Implied warranties of
merchantability or fitness for a particular purpose are
specifically excluded.
For repair or replacement, send the tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporaneous
comments and oral or written agreements concerning
warranties.
NOTE
Observe the gas can expiry date printed on the edge of
the can.