Power Components Service - E-FLITE BNF BASIC UMX AS3Xtra Manuel D'utilisation

Power Components Service

Disassembly
CAUTION: DO NOT handle the propeller
while the fl ight battery is connected to the ESC.
Personal injury could result.
1. Disconnect the battery from the ESC/receiver.
2. Hold the prop shaft using needle-nose
pliers or hemostats.
3. Turn the propeller counterclockwise (facing
the front of the model) to remove. Turn the
propeller clockwise to install.
4. Carefully remove the damaged spinner
and glue from the propeller.
5. Hold the nut on the end of the prop shaft
using needle-nose pliers or hemostats.
6. Turn the gear on the shaft clockwise (facing
the front of the model) to remove the nut.
7. Gently pull the shaft (A) from the gearbox (B).
Make sure the washer (C) and two bushings
(D) are not lost.
8. Disconnect the motor from the
ESC/receiver.
9. Gently push the motor out of the gearbox
and remove the motor from the fuselage.
NOTICE: DO NOT remove the gearbox from
the aircraft. Damage to the aircraft will result.
Assembly
Assemble the aircraft using the instructions
above in reverse order.
• Correctly align the prop shaft gear with the
pinion gear on the motor.
• Connect the motor to the ESC/receiver so
that the powered motor turns the propeller
counterclockwise (facing the front of the
model).
• Make sure the propeller size numbers
(130 x 70) face away from the motor (see
illustration).
• Attach the spinner to the propeller using foam-
compatible CA (Cyanoacrylate adhesive).
All manuals and user guides at all-guides.com
B
A
EN
D C
11