TOPRO OLYMPOS Manuel D'utilisation page 10

Important to know about safety before use
When folding and unfolding, be aware so you do not hurt your fingers.

Check the brakes before use every time, and that the rollator locks in unfolded position.

Not to be used by persons over maximum user weight (see table).

Do not use to transport heavy loads or persons.

The rollator is not a toy.

Make sure that the lock wheel for height adjustment for the handles is locked tight.

Be aware! Some parts of the rollator might feel hot or cold when exposed to extreme temperatures.

Do not alter the product as this might put your safety at risk and the guarantee will not be valid.

Important to know about safety in use
When stationary or parked, always use the parking brakes on both sides A.

Before sitting on the seat, make sure the parking brakes on both sides are in locked position A.

Do not lean or bend sideways or over the back of the rollator whilst in the seated position. Do not tilt the rollator

more than max. 5º sideways, to avoid risk of falling. Due to the same reason bags etc. must never be hung on
the handlebars.
The driving brakes can be held in a little B to reduce speed, but must not be in locked position when the rollator

is in motion.
To give the right support and a safety, make sure the rollator is kept as close to your body as possible C.

Walk straight, look forward and hold your backside in D. That is the easiest way to keep your balance.

Do not push the rollator too far from your body as this can cause unnecessary strain and you could fall.

Be aware that the rollator may roll faster than you walking downhill, which may put you in risk of falling.

Do not use the rollator on stairs. Be careful when descending kerbs.

Be careful of flared skirts and trousers as they could get caught in the wheels, which could lead to falling. We

therefore recommend not wearing flared/wide clothing.
For safety reason it is prohibited to sit on the rollator during public transportation. Place your rollator securely

and use the parking brake.
Assembling / adjusting
TOPRO OLYMPOS is delivered assembled. Before use, you must unfold the rollator. The height of the handlebar
tubes will then need adjusting to suit the user's needs.
Unfolding / folding
Unfolding: Loosen the lock clamp that is over the seat bars A. Press the seat bars down and out B. The side
frames will slide apart. Press down the seat bars. You will hear a clicking sound. The rollator is now locked in its
open position.
Folding: Pull the strap on the seat C and press the side frames together. Lock the clamp D over the seat bars.
Lowering and height adjusting the handles
Lowering: Unscrew the lock wheel for the brake handles A (approx. 4-5 turns). Push the handlebar tubes down
until they stop B. Tighten the lock A again.
Height adjusting: Unscrew the lock for the brake handles A (approx. 4-5 turns). Adjust the handlebar tubes to a
suitable height then pull them slightly up and down C until you hear a clicking sound. Tighten the lock A again.
Adjust both handlebars to the same height. It is recommended that the handlebars should be at the same
height as your wrists when your arms are hanging alongside your body.
Height adjustment using the memory function
You have the opportunity to set the height of the handles at a standard setting, fitting to your height, so that you
easily can find the height again. This can be necessary when the rollator is being transported or stored as
compact as possible. Decide the height of the handlebars. Count visible holes at the back of the handlebar tubes.
Unscrew the lock wheel A. Pull the tube B out of the frame. The attached part C will now follow the handlebar
tube. Move the attached part C on the tube B so the there are equal holes as counted earlier. Fit the memory
chip D on the handlebar tube in the first available hole under the attached part C. Push the handlebar tube B
down and into the side frame E until the attached part is locked. Screw the lock wheel A half in. Pull the
handlebars F up until they stop, and then tighten the lock wheel A properly. From now on, when the handlebars
are in the lowest position, they will stop in the preset position automatically when pulled up.
8
All manuals and user guides at all-guides.com