Start/Stop Demo Driving Programme; Programming Your Own Driving Programme - Reely ROAD Recdrifter Notice D'emploi

• Straight running of the vehicle can be set separately for the front and rear axes. Two
small white levers can be turned to the left and right between the wheels for this.
Adjust them in small steps and check for straight running again afterwards.
• Only drive the vehicle on resilient surfaces, since the hard-plastic tyres required for
the vehicle (for drifting) will otherwise leave scratches.
e) Activating/Deactivating the Headlights
Briefly push the button „B" (10) to activate or deactivate the headlights of the vehicle. One white LED each lights
up in the left and right headlight.
This is only possible if the vehicle is in operation (red LED (3) at the transmitter remains lit (not flashing).
f) Start/Stop Demo Driving Programme
The transmitter has an integrated demo driving programme that can show you the options when driving.
Enough space must be available for the vehicle and it must be put on a smooth underground.
Proceed as follows:
• Start up the vehicle as described above.
• Push the button „C" (12) briefly to start the demo driving programme. The transmitter starts sending the saved
control commands to the vehicle (driving function, steering) and the vehicle moves accordingly.
• To terminate the driving programme prematurely, move the right control lever (7) in any direction.
g) Programming Your Own Driving Programme
The transmitter can save all driving functions within 10 seconds and then repeat them. Changes to driving speed
by the left control lever are saved as well.
Programming:
• Start up the vehicle as described above (red LED (3) must remain lit).
• Select a speed as usual with the left control lever (2).
• Press and hold the button „D" (13) until the right LED (6) flashes green.
• All control commands that you issue in the next 10 seconds (including speed changes via the left control lever)
are saved. The programing mode is then automatically terminated. The right LED (6) goes out.
Calling saved programmes:
• Start up the vehicle as described above (red LED (3) must remain lit).
• Briefly push the button „D" (13). The right LED (6) remains lit green. The saved driving programme is started.
• To prematurely terminate the driving programme, push the button „A" (9) briefly. The red LED flashes slowly.
To drive the vehicle normally again, briefly push the left button „A" (9). The transmitter's left LED (3) flashes
quickly. Move the left control lever (2) all the way forwards once and back again. The left LED (3) at the
transmitter now flashes red permanently.
The vehicle is then ready for use once again.
All manuals and user guides at all-guides.com
27