Charging Battery - Meister AS18VM Traduction Du Manuel D'utilisation Original

5401520-Akkuschrau_man 04.12.14 10:58 Seite 46
• Never operate the charger on a
surface that will burn easily (for
example, paper, textiles etc) or in a
flammable environment. There is a
risk of fire occurring as a result of the
heat generated during the charging
process.
• Do not open the battery. There is a
risk of short-circuiting.
• In the event of damages and
incorrect use, vapours may come
out of the battery. Ensure plenty of
fresh air and, if you have any
symptoms, consult a doctor. These
vapours may irritate the respiratory
system.
Safety marking
The symbols on the housing mean the
following:
Bj. Construction year
SN Series number
Type designation
Motor
Idling speed
Do not dispose of with
domestic waste!
Important! Observe
operating instructions!
„Tested Safety" voluntary
quality mark
CE Mark (conformity to
European safety standards)
Manufacturer's address
46
All manuals and user guides at all-guides.com
7 – Charging battery
CAUTION! This cordless
screwdriver AS18VM may
only be charged using the charger
XR-DC240400A. The charger may
only be operated with a power supply
that has an alternating current of
220–240 V and a frequency of
50/60 Hz. Any use of any other
charger or the charger XR-
DC240400A connected to a power
supply other than the one listed may
lead to personal injury and damages.
The rechargeable battery is not fully
charged on leaving the factory. Charge
the rechargeable battery before first
use.
Withdraw rechargeable battery (3) from
the storage battery drill screwdriver
(Fig. 2).
Connect the charging plug (7) of the
power supply (6) to the charge station (8)
(Figure 3). Connect the power supply to a
power socket (220-240V~).
The red control lamp will light up as
soon as contact is made to the power
supply. Put the empty battery into the
charger, make sure the polarity (+/–) is
correct. The green control lamp will light
up when electrical contact is made.
IMPORTANT! If a recently used
up battery is inserted and the
green control lamp does not light
immediately, remove the battery and
start the charging process again a
few minutes later.