Adjust Door(S) - Jenn-Air JB36SEFXRB Guide D'installation

3. Slide the custom panels into the trims on the refrigerator
door(s) and freezer drawer, making sure that the backer panel
fits into the hinge side trims.
A
4. Reinstall the trims and corner caps.
5. Remove the protective skin from the screw covers. Snap the
screw covers into the handle trim section.
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up; then pull straight out. Place the top grille
panel-side down on a soft working surface.
B
A. Top grille
B. Cabinet side trims
3. Remove one end cap by loosening the nuts and sliding the
end cap off.
24
All manuals and user guides at all-guides.com
A. Panels
A B
A. Bottom rail
B. Nuts
4. Slide the custom panel into the top grille channel and
reattach the end cap.
A
5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
B
Door Alignment (36" [91.4 cm] Models)
1. Loosen, but do not remove, the four Torx
mounting screws and the two ¹⁄₄" hex-head mounting screws
in the top hinge.
2. Adjust the top hinge of the door to align it.
®†
3. Tighten the Torx
of approximately 100 inch-pounds (11.3 Nm).
4. Tighten the ¹⁄₄" hex-head screws.
B
A. Torx
B. ¹⁄₄
"
hex-head mounting screws
C. End cap
D. Top rail
A. Custom panel
A
A. Top grille
B. Cabinet side trims

Adjust Door(s)

®† 27 flat-head
27 flat-head mounting screws to a torque
A
®† 27 flat-head mounting screws
B