IKA LR 1000 basic Mode D'emploi page 35

Support rod:
Screw the support rod onto the LR 1000 basic/control base
with the double open end wrench included with the device
until the end stop is reached.

Installation and connection Pt 100 temperature sensor:
Remove a standard connection NS 14/23 from the reactor
cover for connection the temperature probe.
Screw the LR 1000.61 sensor receptacle with sealing in the
reactor cover.


Pt 100
All manuals and user guides at all-guides.com
Setting up
Attach the reactor vessel to the LR 1000 basic/control
base:
Ensure the LR 1000 basic/control is set up on an even, sta-
ble, clean and non-slip working table.
Set the reactor vessel to the LR 1000 basic/control base
carefully and ensure it is properly attached as indicated in
following image.
Fig. 6
Plug in the probe and pay attention to the minimum immer-
sion depth and freewheeling of the anchor mixer. Fix the posi-
tion in the housing with the two screws for sliding stop.
Connect the temperature probe with the appropriate socket.


CLICK
Unlock
Lock
Fig. 7
Fig. 8
35