Kathrein UFO 331/TP Mode D'emploi page 24

Note: For COFDM modulation the maximum data rate in the output channel is usually lower than the received data rate.
For this reason the channel fi lter must normally be switched off.
If the channel fi lter is switched on, a display appears next to the parameter indicating the current output data rate. Since the data rate can
vary depending on the channel content, the instantaneous and maximum values are displayed.
Note: Only average values that can vary based on channels are displayed. To ensure error-free functioning and plan for
at least 10 to 15 % reserves, i.e. the data rate utilisation should not be above 85 to 90 %.
The "channel fi lter" sub-menu can be exited using the "Sub-menu"
Note: If the maximum possible number of channels carried over is exceeded, an error message appears.
1.13 Transport stream processor: Changing IDs
A 1236
27.500 MS/s
Outp. S21
8 MHz
Main menu
The "IDs" can be set in the TP (Transport stream processor) sub-menu.
The "TP" transport stream processor can be selected using the "<" and ">" buttons, and the sub-menu is called up with the
"Sub-menu" button.
The "IDs" function is selected using the "<" and ">" buttons and the sub-menu is called up using the "Sub-menu" button
Here you can edit the operator ID, the transport stream ID and the original network ID as required.
*** UFO331TP
Filter
IDs
"Transport stream processor" sub-menu
1.13.1 Operator ID (OID)
The "OID" CAT operator ID can be set in the IDs sub-menu. To do so, use the "<" or ">" keys to select "orig" next to the OID parameter
and then use the "+" or "-" to set the "edit" value. The OID value now appears in hexadecimal notation. In the "edit" setting you can
modify the value. To do this, select the value using the ">" key. Use the "+" or "-" key to change the current value in ± 1 increments.
Alternatively you can also select the numeric setting mode by pressing the
by pressing the "+" or "-" keys in ± 1 increments. The values available are "00h" to "FFh".
MHz TP
3/4 QPSK
306.00 MHz
QAM64
***
On
CI
button.
***
Filter
IDs
!
"Transport stream processor" sub-menu
***
OID orig
TSID orig
ONID orig
button. In numeric mode each digit can be modifi ed
10 / 14
UFO331TP
On 62% /
CI
UFO331TP
----h
----h
"IDs" sub-menu
***
76%
.
***