Kathrein UFO 331/TP Mode D'emploi page 27

*** UFO331TP
T / 001 /
Das Erste
Compile
"Filter" sub-menu
To do this, the "<" and ">" buttons may be used to select the parameters and the "+" and "-" buttons to select between "-", "1" and "2".
The settings become effective when the fi lter table is compiled. This is done using the "<" and ">" buttons; select the "Generate"
parameter and use the "+" or "-" buttons to initiate the generation of the channel table.
The menu is exited by pressing the "Sub-menu"
can only exit when the cursor is on the fi lter's "On/Off" parameter.
2. Notes
Note: A description of extended functions such as "Cable NIT compilation", confi guration of "Pass/Drop PID lists",
"Logical Channel Number" assignment etc. can be found in the user instructions for the control elements UFG
300 and USW 30 required for implementing these functions.
For use in older (extension) module carriers, see following note.
Note: When expanding existing systems (still using power supply order no. 1681794), note that the power
supply has a lower rating. Therefore refer to the power rating information on the power supply label.
If the UFG 404 module carrier is used, check that the maximum permissible loading of the power supply unit is
not exceeded.
***
009
/ -
button. If this brings you back to "Transport stream processor" in the sub-menu, you
***
T / 001
/ - Das Erste
Compile
13 / 14
UFO331TP
/ 009
"Filter" sub-menu
***
/ + / 1