Pressure Testing - Falcon 1000 DF Guide De L'utilisateur

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Reassemble
Find the large ring in the conversion kit.
Fit the large ring to the centre burner and assemble the
burner base using the larger internal diameter (10.5mm)
venturi.
10.5mm venturi
the centre burner
All manuals and user guides at all-guides.com
SERVICING - WARNING
7mm venturi
25
Fit the smaller rings to the outer burners
Fit the larger internal diameter (10.5mm) venturis to all the
burners. Tighten the large brass nuts.
an outer burner
Reassemble burner tops, making sure they are
reassembled in the correct way on the burner bodies.
Stick on label
Stick the appropriate label on to the data badge to indicate
the gas the appliance is now set for.

Pressure Testing

Connect the appliance to the gas supply. Check the
appliance is gas sound.
See Technical data section at the back of this book for test
pressures.
The gas pressure can be measured at the pressure test
point on the gas connection block. Turn and light one of the
hotplate burners.
CHECK THE APPLIANCE IS GAS SOUND.
CHECK OPERATION OF ALL THE BURNERS.