Strainer Installation - Conglom QL105 Manuel De L'utilisateur

Installation (continued)

STRAINER INSTALLATION

- Apply plumbing putty or silicone sealant to the top side
of the drain opening .
- Insert the strainer body (1) into the drain opening and
press it down until it is evenly seated .
- Assemble the rubber gasket (2), fiber washer (3) and
strainer locknut (4) onto the strainer body (1) from
underneath the sink . Hand tighten the strainer locknut
(4) until it is snug . Do not overtighten .
- Insert the plastic flange (5) into the flange-end of the
tailpipe (6) (not supplied) then secure the tailpipe to the
strainer body using the connecting nut (7) . Tighten the
connecting nut (7) until it is snug . Do not overtighten .
- Remove excess sealant from around the drain opening .
QL105
Sink
8
Strainer Basket
Strainer Body (1)
Sealant
Rubber Gasket (2)
Fiber Washer (3)
Strainer Locknut (4)
Plastic Flange (5)
Tailpipe (6)
(not supplied)
Connecting Nut (7)