Installing The Strainer - Conglom transform QL014 Manuel De L'utilisateur

Installation (continued)

INSTALLING THE STRAINER

- Apply plumbing putty or silicone
sealant to the top side of the
drain opening .
- Insert the strainer body (12) into the
drain opening and press it down until it
is evenly seated .
- Assemble the rubber gasket (13),
fiber washer (14) and strainer locknut
(15) onto the strainer body (12) from
underneath the sink . Hand tighten the
strainer locknut (15) until it is snug. Do
not overtighten .
- Insert the plastic flange (16) into the
flange-end of the tailpipe (17) (not
supplied) then secure the tailpipe to
the strainer body using the connecting
nut (18). Tighten the connecting nut
(18) until it is snug. Do not overtighten.
- Remove excess sealant from around
the drain opening .
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
Sink
9
Strainer Basket (11)
Strainer Body (12)
Sealant
Rubber Gasket (13)
Fiber Washer (14)
Strainer Locknut (15)
Plastic Flange (16)
Tailpipe (17)
(not supplied)
Connecting Nut (18)
CONGLOMKB .COM