Mounting The Utility Sink; Placement; Drainage; Supply Line - Conglom QL105 Manuel De L'utilisateur

Installation (continued)

MOUNTING THE UTILITY SINK

- Carefully place a bead of sealant all around the top of
the cabinet (A) .
- Ease the sink (C) into the cabinet (A), ensuring that it is
placed evenly and is centered on the cabinet . Wipe off
any excess sealant . Use masking tape to hold the sink
in place until the sealant dries .

PLACEMENT

- Push the cabinet (A) against the wall . Position cabinet
as desired . If required, level it by adjusting the four
leveling feet and checking the alignment of the sink (C)
using a carpenter's level .
IMPORTANT: Secure the cabinet to the wall using hardware best suited for your wall type. Failing to do so could result in
property damage or personal injury.
Use silicone sealant to seal the sink to the wall and any adjacent surfaces to keep those surfaces dry. Failing to do so could
result in moisture damage.

DRAINAGE

- The tailpipe (not supplied) previously installed to the drain can now be connected to your household plumbing . In some cases, your
household plumbing will have to be modified to ensure proper drainage. If so, please consult a licensed plumber to complete
needed modifications.
SUPPLY LINES (NOT INCLUDED)
- Connect the supply lines to your home's water supply
as per manufacturer's instructions .
- Open the hot and cold water supply valves and check
to make sure they have been installed to appropriate
inlet ports . Check for leaks . Run hot and cold water
uninterrupted for about one minute to remove any
residue from the lines .
C
A
9
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
CONGLOMKB .COM