Applications - Generac Mobile Link Manuel Du Propriétaire Et Manuel D'installation

Section 2 General Information
2.1 — Introduction
With this remote monitoring system, the status of the generator can be
checked from anywhere that the owner has access to an Internet connec-
tion from a PC or while traveling with any smart device.
The unit is mounted on the outside of the generator and communicates
with the generator's controller via a serial port. It provides information
about the generator. When the generator is registered with www.Stand-
byStatus.com, the owner can log into this website to check on the cur-
rent status of the generator at any time. It will also notify the owner of any
change in operating status. The owner will be contacted if alarms or warn-
ings occur. When a change in the generator's status occurs, an e-mail or
text message is sent. The delivery method and frequency of these alerts
can be adjusted on the website.
2.2 — Applications
• This unit can be installed on all 2008 and later air-cooled home
standby units, with an LCD display, and all 2010 and later
liquid-cooled gaseous fuel standby units.
• For liquid-cooled units, an additional adapter harness is required
(model 006478-0).
• Suitable for flat surface or surface with a 1355mm radius minimum,
mounting in a Type 3R or rainproof enclosure.
• Power supplied by the engine starting battery is limited to 5 Amps
DC by a fuse in the Mobile Link unit's harness. The fuse is used for
over-current protection of the Mobile Link unit hardware.
• Maximum ambient temperature rating: 122
Mobile Link
° °
F/50 C.
7