SCS Sentinel SCS G Manuel D'installation Et D'utilisation page 37

1. As Fig.7, slide the end rail into the 1st sleeve, slide the middle rail
into the 1
2. As Fig.8, slide the 2
slide the top rail into the 2
3. Remove the plastic film on the end rail , cut the plastic cable tie
on the screw rod "A";
4. As Fig.9, pull the screw rod "A" along with inner chain to the end
of top rail ;
5. As Fig.10, undo the nut & spring;
6. Tight the nut to the right position as shown in Fig.11, cut the plastic
cable tie on sprocket, then whole rail assembled finished.
EN ::: 8
sleeve;
st
sleeve to the other end of middle rail,
nd
nd
Fig. 10
19MM
Fig. 11
sleeve;
B