Télécharger Imprimer la page

Fein JHM Short Slugger Mode D'emploi page 13

Publicité

Les langues disponibles

Les langues disponibles

OBJ_BUCH-0000000070-004.book Page 13 Friday, August 31, 2018 9:25 AM
Working instructions.
When there is danger of falling down, secure the machine using the provided
WARNING
safety strap; especially when working aloft, on vertical building elements or
overhead. In case of a power failure or when the mains plug is pulled, the magnetic holding
power is not maintained.
Fastening the safety strap (figure 6).
Always fasten the machine securely around
the workpiece using the provided safety
strap.
For switching the magnet ON
(figure 7).
Please make sure that the contact surface-
for the magnetic base is level, clean and
rust-free. Remove any varnish or primer.
When working, always use the magnetic
base; ensure that the magnetic holding
power is sufficient.
When working on materials that are non-fer-
rous, suitable fixation devices obtainable as
accessories from the manufacturer, e. g. suc-
tion plates, vacuum plates or pipe-drilling
devices must be used.
When working on steel materials with a
material thickness of less than 12 mm /
the workpiece must be reinforced with an
additional steel plate in order to guarantee the
magnetic holding power.
Press the magnet switch to energize the mag-
net.
1
/
in,
2
en
13

Publicité

loading

Ce manuel est également adapté pour:

7 272