Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000070-004.book Page 16 Friday, August 31, 2018 9:25 AM
en
16
Repair and customer service.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
Exchangeable parts
If required, you can change the following
parts yourself:
Application tools, coolant container, handle,
chip guard, safety strap
Dove-tail guide (figure 11).
After several hours of operation, the play in
the dove-tail guide can increase. As a conse-
quence, the drill motor can glide along the
dove-tail guide by itself. This can lead to the
motor drifting down and damaging the cutting
tool. In this case, retighten all fastening screws
of the dove-tail guide correspondingly so that
the drilling motor can easily be moved manu-
ally, yet does not glide by itself.
Service.
Have maintenance carried out
WARNING
only through qualified person-
nel. Incorrectly mounted cables and compo-
nents can cause serious injuries. Have the
required service carried out only through an
authorized Slugger repair facility.
When replacing the power
CAUTION
tool's protective cable bushing
or cord between the drill stand and drill
motor is required, this must be carried out by
Slugger or by an authorized Slugger Service
Agent, in order to avoid hazardous situations.
The current spare parts list for this power
tool can be found in the Internet at
www.fein.com.
2.
5,0 mm
1.
1.
1.
Cleaning.
Prior to any cleaning or main-
WARNING
tenance, disconnect the power
tool from the power supply in
order to avoid accidents.
When using in environments
WARNING
with conductive dust in the air,
such as when working metals, this dust can
settle in the interior of the power tool. This
can impair the total insulation of the power
tool. Therefore, regularly blow out the interior
of the power tool from outside via the venti-
lation openings with dry, oil-free compressed
air; always wear eye protection when doing
this. For additional protection, connect a
residual current device (RCD) on the line side.
Publicité
