Fein JHM Short Slugger Mode D'emploi page 12

OBJ_BUCH-0000000070-004.book Page 12 Friday, August 31, 2018 9:25 AM
en
12
Changing the tool (figure 5).
When there is danger of falling
WARNING
down, secure the machine
using the provided safety strap; especially
when working aloft, on vertical building ele-
ments or overhead. In case of a power failure
or when the mains plug is pulled, the magnetic
holding power is not maintained.
Before mounting or replacing
WARNING
cutting tool or accessories,
pull the power plug. This pre-
ventive safety measure rules
out the danger of injuries through accidental
starting of the power tool.
Rotate the chip guard away from the arbor.
Loosen both screws of the tool holder using
the hex key.
Insert the pilot pin into the cutter.
Insert the cutter with the pilot pin into the
tool holder.
Tighten both screws of the tool holder onto
the flats on the cutting tool using the hex key.