Troubleshooting; Care And Cleaning; Cleaning; Lubrication - TOOLCRAFT T-HKS 1500 W Notice D'emploi

8. Troubleshooting

By purchasing this circular saw, you have acquired a product design to the state of the art and operationally reliable.
Nevertheless, problems or errors may occur.
The following contains description for the removal of possible interference.
Always observe all safety information in these operating instructions.
Problem
The electrical tool fails to start
The electrical tool starts but does
not cut well. The electrical tool
vibrates a lot.

9. Care and cleaning

Always disconnect the device before performing any adjustment or maintenance operation. If the supply
cord is damaged, it must be replaced by the manufacturer or its service agent in order to avoid a hazard.
a) Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from
various types of commercial solvents and may be damaged by their use.
• Use clean cloths to remove dirt, carbon dust, etc.
• Disconnect from the power supply immediately if the supply cord is damaged.
• Take care not to expose this tool to the rain.
b) Lubrication
All the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under
normal operating conditions, therefore no further lubrication is required.
All manuals and user guides at all-guides.com
Causes
Power supply line disconnected
Plug not inserted
Worn graphite brushes
Electrical fault
Worn, dull or damaged blade
Incorrectly assembled blade
Solutions
Check the electric power supply line
Insert the plug in the electric power
supply socket and press the start button
Contact an authorized service centre
Contact an authorized service centre
Replace the blade
Disassemble the blade and reassemble
it correctly
37