Operation; Installation - TOOLCRAFT T-HKS 1500 W Notice D'emploi

7. Operation

a) Installation
Important! The manufacturer is not liable for any direct and/or indirect damage caused by incorrect
connections.
Important! Before carrying out the following operations, make sure that the plug is disconnected from the
mains.
Take out the machine tool and components and visually check that they are perfectly intact; then proceed to thoroughly
clean them in order to remove any protective oils used for transport.
• Transport
Always use the packaging or case (when provided) when transporting the tool; this will protect it from impact, dust
and humidity which can compromise normal operation.
• Moving
Grip the tool by the hand grip and after use wait for it to stop completely before putting it down.
• Starting up
When choosing where to use the electrical tool, the following should be considered:
- that the place is not damp and is protected from the elements.
- that there should be a large operational area free from obstacles.
- that there is good lighting and sufficient air exchange.
- that it needs to be used close to the general differential switch.
- that the power supply system is earthed and conforms to the standards (only if the electrical tool is class 1, which
is equipped with a plug with earth cable).
- that the room temperature should be between -10°C and 40°C.
- that the environment is not in a flammable/explosive atmosphere.
- that there is a sawdust vacuum fitted with a flexible hose.
• Guide set square adjustment (10)
Insert the guide set square in the guide panel (3) and tighten with the hand wheel. Adjust the distance by observing
the graduated scale on it.
For cutting wide panels do not assemble the guide set square but use a set square made with a strip of wood.
• Assembling the chip vacuum pipe
See figure B.
Connect the electrical tools to a vacuum device for cutting residuals (e.g.
chip vacuum cleaner) using a flexible hose. Insert the piping in the socket
(17) of the tool's casing. For the type suitable for the work, ask your
retailer.
• Assembling batteries for laser indicator or for lighting
Use the batteries supplied and install them in the battery compartment.
32
All manuals and user guides at all-guides.com
Fig. B