Operation; Cutting Angle Adjustment; Cutting Depth Adjustment; Switching On And Off - TOOLCRAFT TCHK 20-LI Solo Mode D'emploi Original

8. Operation

a) Cutting angle adjustment
• Loosen the locking screw for the cutting angle adjustment (5) slightly.
• Set the desired cutting angle using the cutting angle adjustment scale.
• Retighten the locking screw for the cutting angle adjustment (5).
b) Cutting depth adjustment
• Untighten the locking screw slightly to adjust the cutting depth (13).
• Set the desired cutting depth using the cutting depth scale (12).
• Retighten the locking screw for cutting depth adjustment (13).
c) Switching on and off
• Press and hold the switch lock (9) to the left or right.
• Press the on/off switch (10) to turn on the circular saw.
• To turn off the circular saw, simply release the on/off switch (10).
After starting the motor, the switch lock (9) can be released.

9. Troubleshooting

No function, the circular saw cannot be switched on:
• The battery has depleted. Charge the battery using the corresponding charger.
• The battery is not correctly inserted into the battery compartment (11) on the appliance.
The saw blade does not move:
• Immediately switch off the saw and disconnect the battery from the appliance.
• Check if a foreign object is blocking the saw blade.
• Check if any parts have become stuck in the saw blade guard or the oscillating guard (3).
• If necessary, remove the saw blade and/or remove the foreign object.
The saw cut is not clean, the edges of the cut are frayed.
• The saw blade is worn out or damaged and must be replaced.
• A saw blade that is unsuitable for the material or saw cut type is used.
• You put too much pressure on the saw when sawing. Try sawing with less forward pressure.
• Protect sensitive materials (e.g. coated chipboard) with adhesive tape. The adhesive tape prevents fraying at the
cutting edge. A thin block of wood can also be cut at the same time to prevent fraying at the cutting edge.
32