Starting And Stopping; User Instructions - TOOLCRAFT T-HKS 1500 W Notice D'emploi

b) Starting and Stopping
Important! Before starting the electrical tools, it is compulsory to wear all the personal protective
equipment.
Important! Make sure nobody is approaching the working area while the tool is running. Keep safety
distance from all moving parts and from the cutting area.
Important! The motor and the blade continue to run for a few seconds after the tool is switched off. During
this time, these parts must not be touched. Serious injury hazard!
Important! Never press the blade lock button (20) while the blade is moving.
Before starting the machine, check the integrity of all the components and that all the bolts and couplings are right.
• Starting
- See figure A and C.
- Plug the tool into the power supply (8).
- Grip the rear hand grip ( 5) and the front hand grip (4) firmly without
pressing the switch.
- Press the safety button (7) and the switch button (6) in sequence. The
switch is a 'maintained action' switch so the electrical tool will stay on
when you keep the switch pressed.
• Stopping
To stop release the switch button (6) holding the machine firmly.
We recommend repeating these operations several times before starting work, in order to familiarize yourself with
the controls as far as possible.
If you notice any working defects, switch off the electrical tool and consult the chapter "problems, causes and
solutions".
c) User instructions
Important! Before carrying out the following operations, make sure that the plug is disconnected from the
mains.
After reading the previous chapters carefully, apply these tips scrupulously to obtain maximum performance.
Proceed calmly so as to become familiar with all the controls; after having gained sufficient experience you will be
able to make full use of its potential.
• Adjusting the cutting depth
This is obtained by varying the amount the blade sticks out in relation to the guide panel.
Loosen the cutting height adjustment hand wheel (16) and move the guide panel (3) downwards in order to reduce
the cutting depth, and upwards to increase it.
Fix the hand wheel well after adjusting the guide panel in the desired position.
The maximum cutting depth is obtained with an inclination of 0°. Adjust the cutting depth to the thickness of the
panel to be cut; make the teeth stick out only a few millimeters in any case for a lower measurement than the height
of the teeth.
All manuals and user guides at all-guides.com
Fig. C
33