Circular Blade - TOOLCRAFT T-HKS 1500 W Notice D'emploi

Mark the cutting line with a ruler on the piece and position it on trestles. Under the panel, in correspondence with
the cutting line, there must not be any obstacles.
Important! For your safety it is important for the panel to be fixed firmly, so that it doesn't fall once it has been cut,
causing a risk for the operator. Do not cut circular sections, old or fragile wood, irregular wood, cracked wood, wood
with nail or screws, branches or trunk. Always carefully inspect the piece.
• Performing the cut
Some types of panels could chip in the area where the blade comes out: take care to perform the cut resting the
tool on the less important part of the panel.
Carefully fix the piece to be cut, perform all the adjustments to the tools and always connect up the vacuum system
pipe.
Plug the tool into the mains and grip it firmly with both hands (Fig. C); rest the front part of the guide panel on the
edge of the panel (make sure the mobile guard is closed) and start the tool.
Before starting to cut, wait a few seconds so that the electrical tool reaches its full rotation speed.
Slowly move forwards while the mobile guard (9) moves automatically coming into contact with the edge of the
panel. Then maintain the right moving speed to ensure that there is no reduction in the number of revolutions.
Excessive moving speed can cause the blade or the electrical tool to break.
At the end of the cut, release the switch and wait for the blade to stop completely before extracting it from the
material or resting the tool.
Before resting the machine, always check that the mobile guard has completely covered the blade teeth.
d) Circular blade
Important! The cutting part can cause serious injuries – use protective gloves!
- Use good quality blades with the same characteristics as the circular saw based on its technical data – your
retailer will be able to help you make the correct choice. Also observe any instructions provided with the
equipment.
- Do not use blades if you do not know where they are from or without technical specifications. They must show
the nominal dimensions, the number of teeth, the maximum number of revolutions and the arrow indicating the
rotation direction.
- The number of revolutions and the dimensions are the basic elements for making your choice. The number of
revolutions must always be higher or equal to that shown on the machine. The dimensions must be equal to
those shown on the machine.
- Use blades which conform to the regulations in force in the country of use.
- Do not use HSS (high speed steel) blades, abrasive truncating discs or abrasive grinding wheels.
- Always carry out a simple visual check: there must be no deformations, breakages, damage or rust.
• Replacing the blade
See figure E.
Important! Before carrying out the following operations, make sure that the plug is disconnected
from the mains.
All manuals and user guides at all-guides.com
35