Assembly & Set-Up - Cub Cadet FT24 Notice D'utilisation

Assembly & Set-Up
Assembly
References to the right and left side of tiller are
determined from behind the equipment in the
operating position except where otherwise
specified.
Recommended Tools for Assembly
• 1⁄2" wrench
• Clean oil funnel
• Motor oil. Refer to the Engine Operator's
Manual for oil specifications and quantity
required.
Tines
The tines must be installed correctly to ensure
proper operation. See below for the proper tine
installation:
1. The tines must be installed in the correct
location and the correct order. Each tine is
marked as follows:
• A1 — Inner LH Tine
• A2 — Outer LH Tine
• B1 — Inner RH Tine
• B2 — Outer RH Tine
NOTE: Images and descriptions of tine
installation are referenced from the FRONT of
the tiller.
2. Use two clevis pins and two cotter pins
from the manual bag. From the FRONT of
the tiller install the inner LH tines (A1) onto
the inner left side of the shaft. Install the
inner RH tines (B1) onto the inner right side
of the shaft. See Figure 3-1.
Right Side
A1
B1
Figure 3-1
3. Use two clevis pins and two cotter pins
from the manual bag. From the FRONT
of the tiller install the outer LH tines (A2)
onto the outer left side of the shaft. Install
the outer RH tines (B2) onto the outer right
side of the shaft. see figure 3-2.
Right Side
B2
NOTE: The outer tines can be placed in
either of the two outside holes. The inner
hole is for a 22" tilling width and the outer
hole is for a 24" tilling width.
Wheel Assembly & Depth Stake Assembly
1. Remove the remaining clevis pin and
cotter pin from the manual bag, install
the wheel assembly into the chain case
bracket as shown in Figure 3-3.
Left Side
Left Side
A2
Figure 3-2
Figure 3-3
2. Remove the two screws from the bracket
in the chain case. See Figure 3-4.
Figure 3-4
3. Insert the horizontal bracket into the chain
case brackets and secure the depth stake
assembly in place with the screws just
removed in step 2. See Figure 3-4.
NOTE: The depth stake can be placed
at various positions. For setup purposes
it is suggested that the depth stake be
assembled with the stake just above or
level with the ground surface. See the
Operation section for instructions on
setting the tilling depth and adjusting the
depth stake.
Handle
The handle is tilted down and packaged loose
for shipping purposes. To attach the handle,
proceed as follows:
1. Remove the bolts, washers and nuts from
the chain case bracket. See Figure 3-5.
Figure 3-5
2. Place the handle into position and secure
with the previously removed hardware. See
Figure 3-5.
3
5