Key Lock Function - Bosch Climate CL5000i-Set 26 E Notice D'utilisation

Operation
3.6.7 Frost protection (8 °C Heating)
The frost protection can be activated to keep the room temperature at a
minimum of 8 °C.
▶ In heating mode, press the / key 2x within 1 second.
The unit remains off until the temperature falls below 8 °C.
Exiting the function:
▶ Press the K key, Mode key, Turbo key or Clean key.
3.6.8

Key lock function

The keys of the remote control can be locked with the keylock.
▶ To switch the keylock on/off: press the Clean and Turbo keys
simultaneously for 5 seconds.
The symbol appears in the display when the keylock is active.
3.6.9 Advanced operating functions
▶ Press the Set key.
▶ Press the Set key or ., / keys to select the function.
– = Indirect airflow function
– = Fresh air function
– = Sleep mode function
– = Follow me function
– = Wireless control function
▶ Confirm selection with the OK key.
Exiting the function:
▶ Repeat the above steps.
Indirect airflow function (Wind avoid me)
This function prevents a direct airflow onto the body.
The function is only available in cooling mode, dehumidification mode
and fan mode.
Fresh air function (Ionizer)
Ions are released into the room to counteract airborne contaminants
such as mould, viruses and allergens.
Sleep mode
The purpose of this function is to save energy during idle times. After an
hour, the unit heats or cools less intensely. To do this, the set
temperature is changed by 1 °C. After two hours the set temperature
changes by a further 1 °C. The new temperature then remains constant.
The function is not available in dehumidification mode and fan mode.
Follow Me function (Follow Me)
The function activates the remote control at the current location in order
to measure the temperature at 3-minute intervals. The indoor unit is now
controlled with reference to these measurements.
The Follow Me function is only available in cooling mode, heating mode
and automatic mode.
Wireless control function
The purpose of this function is to establish a connection via WLAN. If the
unit is not displaying the function, the LED key must be pressed quickly
seven times in succession instead.
To connect to WLAN an IP-Gateway (accessory) must be installed.
54 Climate 5000i – 6721824789 (2021/02)