Electrical Connection; Rear Spacers; Fitting The Door Handles - Electrolux SANTO 75338-2 DT Notice D'utilisation

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the rating plate cor-
respond to your domestic power supply.
The appliance must be earthed. The power supply cable plug is provided with a contact for
this purpose. If the domestic power supply socket is not earthed, connect the appliance to
a separate earth in compliance with current regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Directives.

Rear spacers

Inside the appliance you find two spacers
which must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the
screw head, then retighten the screws.

Fitting the door handles

The handles are supplied as a kit at delivery.
1. Screw the top handle bracket to the han-
dle rod.
2. Fit the bottom handle bracket on the low-
er right-hand side of the door.
3. Fit the top handle bracket on the top
right-hand side of the door.
4. Screw the handle rod to the bottom han-
dle bracket.
Do not use excessive force and overtighten the
screws (max. 2 Nm) as you may damage the
door handles.
Installation
1
3
33
2
4